Jan 20, 2024 Detailed New 300-430 Exam Questions for Concept Clearance
300-430 Exam Preparation Material with New 300-430 Dumps Questions.
NEW QUESTION # 84
A new MSE with wIPS service has been installed and no alarm information appears to be reaching the MSE from controllers. Which protocol must be allowed to reach the MSE from the controllers?
- A. SOAP/XML
- B. SNMP
- C. CAPWAP
- D. NMSP
Answer: D
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/wireless/mse/7-6/MSE_wIPS/MSE_wIPS_7_6/MSE_wIPS_7_5_chapter
NEW QUESTION # 85
An engineer is performing a Cisco Hyperlocation accuracy test and executes the cmxloc start command on Cisco CMX. Which two parameters are relevant? (Choose two.)
- A. AP name
- B. WLC IP address
- C. X, Y real location
- D. client description
- E. client MAC address
Answer: C,E
Explanation:
Explanation/Reference:
NEW QUESTION # 86
A wireless engineer needs to implement client tracking. Which method does the angle of arrival use to determine the location of a wireless device?
- A. time distance of arrival
- B. angle of incidence
- C. received signal strength
- D. triangulation
Answer: B
Explanation:
NEW QUESTION # 87
An engineer completes the setup of a two-node Cisco ISE deployment for a guest portal. When testing the portal, the engineer notices that sometimes there is a certificate CN mismatch. Which certificate type helps resolve this issue?
- A. Public-Signed Root
- B. Self-Signed Wildcard
- C. Public-Signed SAN
- D. Self-Signed Standard
Answer: B
NEW QUESTION # 88
An engineer must deploy FlexConnect APs to a site that typically has 300 ms latency to the WLC. Which typical operating mode must the engineer plan on for normal operations?
- A. central authentication, local switching
- B. local authentication, local switching
- C. central authentication, central switching
- D. connected mode
Answer: B
Explanation:
Explanation/Reference:
References: http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-2/configuration/guide/cg/ cg_flexconnect.html
NEW QUESTION # 89
An engineer must use Cisco AVC on a Cisco WLC to prioritize Cisco IP cameras that use the wireless network. Which element do you configure in a rule?
- A. WMM required
- B. rate-limit
- C. mark
- D. permit-ACL
Answer: C
Explanation:
NEW QUESTION # 90
An engineer must implement a BYOD policy with these requirements:
Onboarding unknown machines
Easily scalable
Low overhead on the wireless network
Which method satisfies these requirements?
- A. triple SSID
- B. dual SSID
- C. open SSID
- D. single SSID
Answer: D
NEW QUESTION # 91
An engineer is implementing Cisco Identity-Based Networking on a Cisco AireOS controller. The engineer has two ACLs on the controller. The first ACL, named BASE_ACL, is applied to the corporate_clients interface on the WLC, which is used for all corporate clients. The second ACL, named HR_ACL, is referenced by ISE in the Human Resources group policy. What is the resulting ACL when a Human Resources user connects?
- A. HR_ACL appended with BASE_ACL
- B. BASE_ACL only
- C. BASE_ACL appended with HR_ACL
- D. HR_ACL only
Answer: D
Explanation:
https://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/98590-Per-User-ACL-WLC.html#configure-acs
NEW QUESTION # 92
The network management team in a large shopping center has detected numerous roque APs from local coffee shops that are broadcasting SSIDs. All of these SSlDs have names starting with ATC (for example. ATC302.
ATC011. and ATC566). A wireless network engineer must appropriately classify these SSIDs using the Rogue Rules feature. Drag and drop the options from the left onto the categories in which they must be used on the right. Not all options are used.
Answer:
Explanation:
Explanation
Diagram Description automatically generated
NEW QUESTION # 93
An engineer is using Cisco Prime Infrastructure reporting to monitor the state of security on the WLAN.
Which output is produced when the Adaptive wIPS Top 10 AP report is run''
- A. last of 10 monitor mode APs with the most wIPS events
- B. last of 10 sniffer mode APs with the most wIPS events
- C. last 10 wIPS events from sniffer mode APs
- D. last 10 wIPS events from monitor mode APs
Answer: D
NEW QUESTION # 94
An engineer is deploying a virtual MSE. The network has 3000 APs and needs 7000 IPS licenses. To which size server does the engineer scale it?
- A. standard
- B. low end
- C. virtual
- D. high end
Answer: D
NEW QUESTION # 95
An engineer is setting up a WLAN to work with a Cisco ISE as the AAA server. The company policy requires that all users be denied access to any resources until they pass the validation. Which component must be configured to achieve this stipulation?
- A. AAA override
- B. preauthentication ACL
- C. WPA2 passkey
- D. CPU ACL
Answer: A
Explanation:
Explanation
http://mvwxiscoxom'c/en/us/support/docs/wjreless-rnobility/wlan-security/71978-acl-wic.pdf
NEW QUESTION # 96
Where is Cisco Hyperlocation enabled on a Cisco Catalyst 9800 Series Wireless Controller web interface?
- A. Flex Profile
- B. AP Join Profile
- C. Policy Profile
- D. RF Profile
Answer: B
Explanation:
https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/cisco-hyperlocation.html
NEW QUESTION # 97
Which configured is applied to prevent the network from a Layer 2 flooding of multicast frames with a seamless transfer of multicast data to the client when roaming from one controller to another?
- A. Create multicast groups on the central Layer 3 switch.
- B. Enable IGMPv3 on the central Layer 3 switch.
- C. Enable multicast mode on the WLC
- D. Enable IGMP snooping on the WLC
Answer: D
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONS
NEW QUESTION # 98
Which two protocols are used to communicate between the Cisco MSE and the Cisco Prime Infrastructure network management software? (Choose two.)
- A. Telnet
- B. HTTPS
- C. SSH
- D. NMSP
- E. SOAP
Answer: B,D
Explanation:
https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/33/user/guide/bk_CiscoPrimeInfrastructure_3_3_0_UserGuide/bk_CiscoPrimeInfrastructure_3_3_0_UserGuide_chapter_0100110.html
NEW QUESTION # 99
On a branch office deployment, it has been noted that if the FlexConnect AP is in standalone mode and loses connection to the WLC, all clients are disconnected, and the SSID is no longer advertised. Considering that FlexConnect local switching is enabled, which setting is causing this behavior?
- A. 802.11r Fast Transition is enabled
- B. ISE NAC is enabled
- C. Client Exclusion is enabled
- D. FlexConnect Local Auth is disabled
Answer: D
NEW QUESTION # 100
An engineer configured a Cisco AireOS controller with two TACACS+ servers. The engineer notices that when the primary TACACS+ server fails, the WLC starts using the secondary server as expected, but the WLC does not use the primary server again until the secondary server fails or the controller is rebooted. Which cause of this issue is true?
- A. DNS query is enabled
- B. DNS query is disabled
- C. Fallback is disabled
- D. Fallback is enabled
Answer: C
Explanation:
NEW QUESTION # 101
An engineer is deploying a virtual MSE. The network has 3000 APs and needs 7000 IPS licenses.
To which size server does the engineer scale it?
- A. standard
- B. low end
- C. virtual
- D. high end
Answer: D
NEW QUESTION # 102
On a branch office deployment, it has been noted that if the FlexConnect AP is in standalone mode and loses connection to the WLC, all clients are disconnected, and the SSID is no longer advertised. Considering that FlexConnect local switching is enabled, which setting is causing this behavior?
- A. 802.11r Fast Transition is enabled
- B. ISE NAC is enabled
- C. Client Exclusion is enabled
- D. FlexConnect Local Auth is disabled
Answer: D
Explanation:
NEW QUESTION # 103
......
300-430 2024 Training With 218 QA's: https://pass4sure.dumps4pdf.com/300-430-valid-braindumps.html