[Nov-2024] CWNP CWT-101 Dumps – Reduce Your Chance of Failure in CWT-101 Exam
To help you achieve your ultimate goal, we suggest the actual CWNP CWT-101 dumps for your CWNP Certified Wireless Technician (CWT) exam preparation to use as your guideline.
NEW QUESTION # 79
What does output power control allow you to do in the configuration of an AP?
- A. Change the channel
- B. Implement Dynamic Frequency Selection (DFS)
- C. Increase or reduce the output power
- D. Increase or reduce the antenna gain
Answer: D
NEW QUESTION # 80
What term is used to describe the phenomenon of an RF signal bouncing off a surface?
- A. Scattering
- B. Reflection
- C. Refraction
- D. Gain and loss
Answer: B
NEW QUESTION # 81
Some APs come with a captive portal available within the AP, controller or cloud interface. For what would this captive portal most likely be used?
- A. Employee access
- B. Long-term contractor access
- C. Executive management access
- D. Guest access
Answer: D
NEW QUESTION # 82
In what way are 802.11 channels defined?
- A. By a low frequency and channel width
- B. By channel width alone
- C. By a high frequency and channel width
- D. By a center frequency and channel width
Answer: B
NEW QUESTION # 83
How many channels are available in the 2.4 GHz frequency band in all regulatory domains?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION # 84
Which type of mount is commonly used for installing an 802.11 AP on a pole or mast?
- A. Pole/mast mount
- B. Ceiling mount
- C. Floor mount
- D. Wall mount
Answer: A
NEW QUESTION # 85
What does dual-band refer to in the context of an 802.11 AP?
- A. Support for two different frequency bands
- B. Multiple-SSID support for guest access
- C. Support for two simultaneous wireless connections
- D. Ability to operate in two operational modes
Answer: A
NEW QUESTION # 86
A device is a 3x2:2 device.
How many spatial streams can it receive?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION # 87
What do antenna pattern charts represent?
- A. Available channels by protocol
- B. Co-Channel Interference (CCI) and Co-Channel Contention (CCC)
- C. Antenna patterns and signal coverage areas
- D. Regulatory constraints on channel selection
Answer: C
NEW QUESTION # 88
What are some common causes of performance problems in wireless networks?
- A. Configuration errors
- B. Interference
- C. Co-channel interference (CCI)
- D. Low data rates
Answer: A
NEW QUESTION # 89
Which configuration option allows an 802.11 AP to receive power through an Ethernet connection?
- A. Single-band vs. dual-band
- B. Output power control
- C. PoE support
- D. PHY and frequency band support
Answer: C
NEW QUESTION # 90
Which component of a wireless device needs to be configured for optimum performance, such as band preference and regulatory domain?
- A. Client drivers
- B. Transmit power
- C. Channel widths
- D. Supported channels
Answer: A
NEW QUESTION # 91
You have recently changed the passphrase used with WPA2 in several APs and have reconfigured clients for the new passphrase. Now, a few clients are unable to connect to those APs. Most clients can connect to them just fine.
What is the likely problem?
- A. The problem clients are not 802.11-capable
- B. The APs have the wrong new passphrase
- C. The problem clients have the wrong passphrase
- D. The working clients have the wrong passphrase
Answer: C
NEW QUESTION # 92
Which process in the WLAN connection sequence involves verifying the identity of the client device?
- A. Association
- B. 802.1X/EAP authentication
- C. Authentication
- D. 4-way handshake
Answer: C
NEW QUESTION # 93
Which feature of an 802.11 AP allows separate wireless networks to be established for guest access?
- A. Single-band vs. dual-band
- B. Multiple-SSID support
- C. PHY and frequency band support
- D. Guest access
Answer: D
NEW QUESTION # 94
......
Accurate & Verified Answers As Seen in the Real Exam here: https://pass4sure.dumps4pdf.com/CWT-101-valid-braindumps.html