[2026] 350-801 by CCNP Collaboration Actual Free Exam Practice Test
Free CCNP Collaboration 350-801 Exam Question
NEW QUESTION # 96
An engineer must manually register an analog port with cisco UCM using the MGCP protocol.
Which commands are required?
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: A
NEW QUESTION # 97
What must be configured on a Cisco Unity Connection voice mailbox to access the mailbox from a secondary device?
- A. mobile user
- B. Attempt Forward routing rule
- C. alternate names
- D. alternate extensions
Answer: D
Explanation:
To access a Cisco Unity Connection voice mailbox from a secondary device, you must configure an alternate extension for the mailbox. This is a phone number that is different from the mailbox's primary extension. When you call the alternate extension, you will be prompted to enter the mailbox's PIN. Once you have entered the PIN, you will be able to access the mailbox just as you would if you were calling from the primary device.
NEW QUESTION # 98
Users dial a 9 before a 10-digit phone number to make an off-net call All 11 digits are sent to the Cisco Unified Border Element before going out to the PSTN The PSTN provider accepts only 10 digits. Which configuration is needed on the Cisco Unified Border Element for calls to be successful?
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: A
NEW QUESTION # 99
What will DiffServ provide?
- A. scheduling technique
- B. traffic classification
- C. service differentiation
- D. queuing mechanism
Answer: B
NEW QUESTION # 100
Refer to the exhibit.
Refer to the exhibit. An administrator configured a codec preference list with 0,122 and ILBC codecs. Which change must the administrator make in the dial-peer section of the configuration to use this list?
- A. add codec preference 20
- B. add voice-codecs 20
- C. add session codec 20
- D. add voice-class codec 20
Answer: D
NEW QUESTION # 101
What are two key features of the Expressway series? (Choose two.)
- A. B2B calls
- B. SIP header modification
- C. VPN connect toward the internal UC resources
- D. IP to PSTN call connectivity
- E. Device registration over the internet
Answer: A,E
Explanation:
https://www.cisco.com/c/en/us/products/collateral/unified-communications/expressway- series/datasheet-c78-737605.html
NEW QUESTION # 102
An administrator recently upgraded a Cisco Webex DX80 through its web interface but discovered the next morning that the unit has received to its previous version. What must the administrator do to prevent this from happening again?
- A. Assign a universal device template to the phone.
- B. Set the prepare cluster for rollback to pre-8-0 enterprise parameter to true.
- C. Assign a phone security profile with secure SIP.
- D. Confirm the phone load name in the phone configuration.
Answer: D
NEW QUESTION # 103
What are two key features of the Expressway series? (Choose two.)
- A. B2B calls
- B. device registration over the Internet
- C. SIP header modification
- D. IP to PSTN call connectivity
- E. VPN connection toward the internal UC resources
Answer: A,B
NEW QUESTION # 104
According to the QoS Baseline Model, drag and drop the applications from the left onto the Per-Hop Behavior values on the right.
Answer:
Explanation:
NEW QUESTION # 105
Which two types of device are supported by the Bulk Administration Tool? (Choose two.)
- A. Cisco Unified IP phones (all models)
- B. music on hold servers
- C. SIP trunks
- D. H.322
- E. H.225 trunks
Answer: A,D
Explanation:
Section: Protocols, Codecs, and Endpoints
NEW QUESTION # 106 
Refer to the exhibit. What is the registration state of the analog port in this debug output?
- A. The analog port is registered to Cisco UCM.
- B. The analog port failed to register to Cisco UCM with an error code 200.
- C. The MGCP Gateway is not communicating with the Cisco UCM.
- D. The analog port is currently shut down.
Answer: A
NEW QUESTION # 107
As a voice engineer, which two recommendations do you make to your company to optimize Cisco Unified Communications Manager configuration to reduce the number of toll fraud incidents? (Choose two.)
- A. Inbound CSS on any gateway typically should have access to internal destinations and PSTN destinations.
- B. Classify all route pattern as off-net and prohibit off-net to off-net call transfers in Cisco Unified CM service parameters.
- C. Classify all route patterns as on-net or off-net and prohibit off-net call transfers in Cisco Unified CM Service parameters.
- D. Classify all route patterns as on-net and prohibit on-net to on-net call transfers in Cisco Unified CM service parameters.
- E. Inbounds CSS on any gateway typically should have access to internal destinations only and not PSTN destinations.
Answer: B,E
NEW QUESTION # 108
The chief officer at a company must reduce collaboration infrastructure costs by onbording all on-permises equipment to the cloud by using CISCO Webex Control Hub. Administrators need the ability to manage upgrades and set up hot desking for on-premises devices.
Which action must be taken before on boardng devices by using the Control Hub?
- A. Configure tie Control Hub organization ID on the devices
- B. Allow HTTP traffic from each device to Control Hub.
- C. Acquire a license for each device.
- D. Upgrade all the devices to software version CE9.15 or later
Answer: D
Explanation:
This is a prerequisite for using the Device Connector tool, which allows you to onboard and register several devices simultaneously to the Webex Control Hub1. The Device Connector tool creates a workspace, an activation code, and activates all of your devices in one go1. This way you don't need to be physically present in the same room to activate the devices.
The other options are not required before onboarding devices by using the Control Hub:
Configuring the Control Hub organization ID on the devices is not necessary, as the Device Connector tool will send the device information to your Webex organization and generate activation codes for them1.
Acquiring a license for each device is not necessary, as you can assign licenses to users and devices after they are registered to the Webex Control Hub2.
Allowing HTTP traffic from each device to Control Hub is not necessary, as HTTPS connectivity is required for the Device Connector tool to communicate with the devices1.
NEW QUESTION # 109
When configuring Cisco Unified Communications Manager,
which configuration enables phones to automatically register to a Cisco Unified Communications publisher when the connection to the subscriber is lost?
- A. Cisco Unified CM Group
- B. SRST
- C. Route Group
- D. Device Pool
Answer: A
NEW QUESTION # 110
Refer to the exhibit.
A customer reports that MTP resources are being used in the recently deployed Cisco UCM and wants no MTP resources to be used. Cisco UCM SIP trunk configuration does not have the MTP Required box checked Which configuration change resolves the issue?
- A. Change Cisco Unified Border Element configuration to "dtmf-relay rtp-nte".
- B. Change Cisco Unified Border Element configuration to "dtmf-relay sip-notify sip-kprnl".
- C. Change Cisco UCM SIP trunk DTMF Signaling Method to "sip-kpml".
- D. Change Cisco UCM SIP trunk DTMF Signaling Method to -sip-notify".
Answer: A
NEW QUESTION # 111
What is the purpose of configuring locations in a Cisco Webex dial plan?
- A. to restrict access to international calling capabilities
- B. to identify the location of Webex data centers
- C. to organize calling features within the same physical location
- D. to restrict access to long distance calling capabilities
Answer: C
NEW QUESTION # 112
When configuring Cisco UCM, which configuration enables phones to automatically reregister to a Cisco UCM publisher when the connection to the subscriber is lost?
- A. SRST
- B. Route Group
- C. Device Pool
- D. Cisco UCM Group
Answer: A
Explanation:
Section: Infrastructure and Design
Explanation:
Cisco Unified SRST provides Cisco Unified CM with fallback support for Cisco Unified IP phones that are attached to a Cisco router on your local network. Cisco Unified SRST enables routers to provide call-handling support for Cisco Unified IP phones when they lose connection to remote primary, secondary, or tertiary Cisco Unified CM installations or when the WAN connection is down.
Reference:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cusrst/admin/sccp_sip_srst/configuration/guide/ SCCP_and_SIP_SRST_Admin_Guide/srst_overview.html
NEW QUESTION # 113 
Refer to the exhibit. An administrator must fix the SRV records to ensure that server1. sample.com is always contacted first from the three servers. Which solution should the engineer apply to resolve this issue?
- A. Priority = 100, Weight = 90
- B. Priority = 10, Weight = 10
- C. Priority = 10, Weight = 5
- D. Priority = 5, Weight = 70
Answer: D
NEW QUESTION # 114
An engineer is working on a SIP integration between Cisco UCM and Cisco Unity Connection and must add an additional TFTP server Drag and drop the configuration steps from the left into the correct order on the right.
Answer:
Explanation:
NEW QUESTION # 115 
Refer to the exhibit. An administrator configures fax dial-peers on a Cisco IOS gateway and finds that faxes are not working correctly Which change should be made to resolve this issue?
- A. codec g711ulaw
- B. codec g726r32
- C. codec g729br81
- D. codec g723ar63
Answer: A
NEW QUESTION # 116
How are network devices monitored in a collaboration network?
- A. The Cisco Discovery Protocol table is shared among devices.
- B. System logs are collected in a Cisco Prime Collaboration Server.
- C. Simple Network Managed Protocol is enabled on each device to poll specific values periodically.
- D. Ping Sweep reports "unmanaged' state devices.
Answer: B
NEW QUESTION # 117
How does an administrator make a Cisco IP phone display the last 10 digits of the calling number when the call is in the connected state, and also display the calling number in the E.164 format within call history on the phone?
- A. Change the service parameter Apply Transformations On Remote Number to True.
- B. Configure a calling party transformation pattern that keeps only the last 10 digits.
- C. Configure a translation pattern that has a Calling Party Transform Mask of XXXXXXXXXX.
- D. On the inbound SIP trunk, change Significant Digits to 10.
Answer: B
NEW QUESTION # 118
A user dials 9011841234567 to reach Vietnam. Which steps send the call to the PSTN provider as 011841234567?
- A.
- B.
- C.
- D.
Answer: C
NEW QUESTION # 119
An end user at a remote site is trying to initiate an Ad Hoc conference call to an end user at the main site. The conference receives an error message on the phone: Cannot complete conference call. What is the cause of the issue?
- A. The remote phone does not have the conference feature assigned
- B. A software conference bridge is not assigned.
- C. A Media Termination Point is missing.
- D. The transcoder resource Is missing.
Answer: D
NEW QUESTION # 120
Where in Cisco UCM are codec negotiations configured for endpoints?
- A. in in-service parameters
- B. in enterprise parameters
- C. under device profiles in device settings
- D. under regions using preference lists
Answer: D
NEW QUESTION # 121
......
Cisco 350-801 Actual Questions and Braindumps: https://pass4sure.dumps4pdf.com/350-801-valid-braindumps.html